![]() Pretty simple, I wouldn’t however ask much more from her. Also, when the red circle button is pressed while recording. After a few guesses she would identify that the red circle button starts recording when pushed. It’s a camera I could hand to by mother and ask her to film something without much instruction. “Important” Product + Safety InformationĪ great feature to the GoPro Session is it’s simplicity of use. ![]() Standard buckle (display mounting buckle).It provides stiff resistance to a ball joint that allows for about 15 degrees of angle and 360 degrees of rotation for the camera mount. New for GoPro’s is the Ball Joint buckle. There are two adhesive mounts, one curved which is perfect for a helmet and another was flat for flat objects. The offset mount provides a bit of a nested feel while the other stands the Session up higher off an object like a helmet or handle bar. Also included is a curved offset mount, and a flat mount used that work with both frames. This is great for flat mounting, or side mounting. The other frame is the standard frame, which is used to mount the GoPro Session from the bottom. One has the mounting for the back of the camera, that is great for mounting the camera out in front of objects, or nested mounting. There are two frames for the camera that are included. Inside the box includes the Hero4 GoPro Session Camera. Under the paperwork are two separate compartments that hold all the mounts, frames, screws, cables etc. Opening up the inside of the box reveals the quick start guide, warranty information, and stickers. It’s great for placing on flat surfaces like a desk top to film with. The GoPro is attached to the inside with a quick release and a base plate that can be removed with some work to use as an additional mount, so hang onto it. Also, it can be removed by squeezing the tabs of the mount and sliding it off the box mount. To remove the GoPro unscrew the frame from the mount, there is also a small plastic lever that can be discarded that keeps the Session from rotating in the packing. The GoPro Hero4 Session is attached to a base plate that is stuck to the top of the cardboard box with 4 adhesive points. Just pull the tap and the plastic top will separate from the box revealing the GoPro. Once the sleeve is removed, there is a long plastic tape that runs around the entire plastic top, connecting it to the bottom cardboard box. This will release the specification sleeve. To unpack the Hero4 Session, first break the seal on the two circle clear stickers on the side of the box. Currently, most GoPro packaging comprises of a cardboard bottom sleeve, inner box and a hard clear plastic top. Opening a GoPro packing for the first time can be a little confusing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |